Monday, September 23, 2013

How to create a broom of Plastic Bottle

Another great idea to recycle plastic bottles. Learn now to make my brush with the hardware.

You will need:

     A broomstick
     PET bottles of the same brand
     scissors
     A small nail
     Thin wire

How to:
 
 
Middle picture follow tudopor above. Click to enlarge if necessary.

Remove the label. Cutting the bottom of the bottle and then cut thin webs to the vertical.

To do this, five bottles. Remove the mouth and keep all four of them with the last mouth.

You must meet the bottles without spout inside he was with his mouth. Put into one another.

Finally, another bottle to gas using a funnel. Snap above all.

With a hot nail to poke two holes on all cylinders and run the wire to hold them all.
 
 
Finally, plug the cable into the bottle tip. Preach not to come off. That's it! 

Penguin pet bottle - step by step



The idea of ​​recycling plastic bottles is really great and beautiful! The little penguins were taken quickly and without work. Want to learn? See the walkthrough!

You will need:

     PET bottles that have the same shape (two bottles of each penguin)
     scissors
     The white school glue
     Small flat brush
     Scissors or a knife
     Pompon wool color
     Bits of colored cloth and stamped
     Gouache or acrylic paint, assorted colors
     hot glue

How to


Cutting the basis of a polyethylene bottle, and half on the other. Discard the remaining parts.     Attach one bottle to another.
     Cole lest they fall.
     Mix one part white glue to two parts of white paint and paint the frame.
     Draw the front of the Penguin body.
     Ink is black (ink glue mixture again).
     Paint above all in red ink.
     Blue ball draw the top of the structure.
     Draw the face of the penguin.
     Glue a strip of cloth to symbolize a scarf.
     Glue pompom wool on the head to finish the ceiling was created.

Ready
!

how make beautiful flowers with paper?

To make a pretty flower bouquet must

A packet of tissue compact type
Some handkerchiefs box or toilet paper it also works
White thread
Wire a tiger flowers or other
Adhesive tape
The floral tape
Of acrylic paint (any color)
A flat brush
  




Very gently tear the tissue into two equal parts
  with the help of the center fold of tissue


Then tear the edge of the two pieces for an irregular edge




 The two sheets lay one upon the other and shaped accordion fold




Establish the accordion in the middle




and begin to gently raise the paper layers to the center
  there are six on each side




Here is your complete flower




You can leave it as that and use it as decoration on a table, tree, or anything that goes through your head and then make a real flower with a stem, see how

We must wire tiger
A thin handkerchief or two pieces of toilet paper
Adhesive tape
And the floral tape


Take the wire and insert the node in the white wire and fold about 2 cm and twist slightly




Take the handkerchief, folded to make it about 1 inche and wrap it around the wire, leaving an edge more than a little to the narrowing to the stem

   
Once rolled around, close with tape


Properly push the tube on the base of the flower and tie down winding the tape on the end and at the same time on the wire so it does not slip


Then take the floral tape and wrap it over the white base


We can go to the bottom by inserting small leaves made ​​of green crepe paper, but I did not have the right color I stopped a few inches, that's what it looks like finished


Again, you can leave it, if you want a white carnation, but you can also paint slightly to align with other flowers, for example, or the vase is either

I chose to paint
To do this, take the acrylic paint color of your choice
And a flat brush


Load the brush slightly and lightly rub the edges of the flower without overloading paint




And now the flower is finished


There are more than put with all the other


Thank you :)               
 
Themes by Bonard Alfin Blogger Templates - Studio Rekaman - Alat Recording